According to the regulations of 743-84 in the list of China's international Gb3 Beijing automobile maintenance center, the fuel consumption ratio is less than 1%. According to the calculation, the engine displacement of 1.6 is - 2.0L, while the oil consumption of 100 km (15 urban cycle conditions) to 10 L vehicles should be less than 1 L / 1000 km, oil consumption and general oil consumption. If you find that the fuel consumption is too high, you should read the following article.

　　漏油導致油耗增加

　　Increased oil consumption due to oil leakage

　　1. 檢測方法

　　1. Test method

　　A.首先應仔細清潔發動機外表面。然后，發動機應啟動一段時間，并將其停放在干凈的地面上;請再次查看引擎的表面，看是否有漏油的跡象。如果你發現有油滴在某處，這可能就是你要找的漏洞之源。

　　A. The outer surface of the engine should be cleaned carefully first. Then, the engine should be started for a period of time and parked on a clean ground; please check the surface of the engine again for signs of oil leakage. If you find oil drops somewhere, this may be the source of the leak you are looking for.

　　B.用破布塞住發動機的曲軸箱排氣(管)和加油嘴，使發動機怠速運轉;壓縮空氣通過測油口或加油噴嘴泵入曲軸箱。這為您提供了一個更可見的石油泄漏視圖，并允許您跟蹤泄漏源。通過以上檢查，基本可以找到漏油現場。

　　B. Plug the crankcase exhaust (pipe) and oil nozzle of the engine with rags to make the engine run at idle speed; the compressed air is pumped into the crankcase through the oil measuring port or oil nozzle. This gives you a more visible view of the oil spill and allows you to track the source of the spill. Through the above inspection, we can basically find the oil leakage site.

　　2. 治療

　　2. Treatment

　　A.所選新墊片應處于良好狀態。一旦發現局部斷裂等質量問題，不能強力使用。購買新的墊片使用前應在原包裝盒中完好地存放，決不隨意堆放，使其彎曲或重疊，更不能掛在掛鉤上放置。

　　A. The new gasket selected should be in good condition. Once quality problems such as local fracture are found, it cannot be used forcefully. Before using, the new gasket shall be stored in the original packing box in good condition, and shall not be stacked randomly to make it bent or overlapped, and shall not be placed on the hook.

　　B.安裝新墊片前，接縫表面應處理好，使接縫表面光潔無垢。同時，對接頭表面進行翹曲檢查。

　　B. Before installing the new gasket, the joint surface shall be well prepared to make the joint surface clean and free of scale. At the same time, check the warpage of the joint surface.

　　C.各墊片漏油時，先將泄漏區域的螺絲均勻有序地擰緊。如果泄漏仍然存在，更換新的墊圈。

　　C. When the gasket leaks oil, tighten the screws in the leakage area evenly and orderly. If the leak persists, replace the gasket with a new one.

　　大多數車主發現該車有非正常耗油、漲價的情況，可能是漏油造成的，所以我們應該經常設定北京奧迪A3保養價格周期來檢查油罐。如果發現漏油，應該及時修復，比如更換完好無損的新襯墊。所以如果漏油情況非常嚴重，應該開車到4S店進行專業維修。

　　Most car owners find that the car has abnormal fuel consumption and price increase, which may be caused by oil leakage. Therefore, we should often set a Beijing Audi A3 maintenance price cycle to check the oil tank. If oil leakage is found, it should be repaired in time, such as replacing the intact new gasket. So if the oil leakage is very serious, you should drive to the 4S shop for professional maintenance.

　　以上是濟南奧迪汽車維修公司小編為大家介紹的相關內容，想要了解更多內容，歡迎訪問網站：http://www.cnjqf.com

　　These are the relevant contents introduced by Jinan Audi automobile maintenance company. If you want to know more, please visit the website: http://www.cnjqf.com